Factory attendance system
A factory tests an attendance system harder than any office: hundreds of people at shift change, night shifts that cross midnight, contract labour that changes every week and hands that fingerprint sensors cannot read. Here is what works.
The challenge
What makes it hard
- Hundreds of workers punching in the same ten minutes
- Night shifts that start on one day and end on the next
- Contract and temporary workers joining and leaving every week
- Worn, oily or dusty fingers that fingerprint sensors reject
- Overtime and shift allowances that payroll has to get right
- Proxy punching for absent colleagues
What works
The recommended setup
Use face terminals at the gates, and enough of them for the shift-change peak: one terminal handles a steady stream, while a main gate at shift change usually needs two or more side by side. Palm-vein readers are an alternative where cameras are unwelcome. Put contract workers on their own terminals or labels if an agency pays them, and use cards or face at the canteen.
Connect every gate and every plant to one account, so HR sees all of them together, and send punches to the payroll or ERP system with night shifts booked to the day they started. Make sure removing a contract worker is a single step that takes them off every gate at once.
Buyer's checklist
- Enough terminals for your shift-change peak
- Face or palm recognition for damaged fingers
- Night shifts kept as one shift on the day they started
- Quick enrolment and removal of contract labour
- Dust-tolerant terminals with battery backup
- Integration with your payroll or ERP
Machines that suit it
- Face recognition attendance machines
- Palm and palm vein attendance machines
- RFID card attendance machines
Software it often feeds
Factory-grade terminals from Cams
Cams' multi-face terminals recognise several workers at once at a gate, and every punch goes through the Cams cloud to your payroll or ERP.
FAQ
Attendance for factories: questions
Why do fingerprint machines fail in factories?
Manual work wears, cuts and dirties fingers, so the sensor cannot read them reliably. Face or palm-vein recognition does not depend on the skin of the fingertips.
How should night shifts be handled?
A good system pairs each check-in with the next check-out within a set limit and books the shift to the day it started. Ask how a 22:00 to 06:00 shift appears in payroll before you buy.
How do we stop proxy punching?
Use a biometric rather than cards alone (face is the hardest to cheat at a gate) and place terminals where security can see them.
Can contract workers be enrolled and removed quickly?
Yes, when terminals are managed from the cloud: enrol a worker once, sync them to every gate, and remove them from all gates the day they leave.